Operation and use
2G40, 2G40 H
38
HATZ
Operator’s Manual
Procedure – Starting the engine with a starter
NOTICE
i
▪
Start for max. 30 seconds. If the engine is still not running
after that, turn the starting key back to position "0" and elimi-
nate the cause (see chapter
).
▪
Turn the starting key to position "0" every time you want to
start the engine.
▪
The anti repeat device in the ignition lock makes it impossi-
ble for the starter to engage while the engine is running and
become damaged.
NOTICE
i
The starter protection module prevents the starter from engag-
ing while the engine is running and becoming damaged.
▪
The starter protection module is required when the user
cannot detect at the ignition lock if the engine is still running
or is already at a standstill.
▪
In models equipped with a starter protection module, the
starting key must be kept in the 0 position for at least 8 sec-
onds before another start is possible after the engine is
switched off.
Step
Activity
1
Check the speed adjustment (see chapter
2
Remove the protective cap (1) from the ignition lock.
3
Insert the starting key all the way and turn to position "I".
When the pre glow display (3) lights up, wait until it goes out
then continue with step 4.
4
Turn the starting key to position "II".
5
As soon as the engine is running, release the starting key.
▪ The starting key springs back to position "I" and remains in
this position during operation.
▪ The charge control (7) and oil pressure display (6) go out.
▪ Operating display (8) lights up and signals there is no engine
fault.
