10/6/10
888-2629-200
A-9
WARNING: Disconnect primary power prior to servicing.
Maxiva ULX COFDM Series
Warning
IN THE FOLLOWING MIXING PROCEDURE, ALWAYS PUT WATER IN THE CON-
TAINER FIRST AND THEN ADD ACID TO THE WATER. ADDING WATER TO A CON-
TAINER OF ACID MAY RESULT IN A VIOLENT & DANGEROUS REACTION.
1.
Prepare three plastic 5 gallon buckets as follows:
A.
Bucket #1 - Water
B.
Bucket #2 - One quart muriatic acid in four gallons of water (See Warnings
Above)
C.
Bucket #3 - One pound baking soda in five gallons of water
2.
After soldering is finished, dip the end of the line in the water to cool.
3.
Set the cooled end of the line into the acid-water mixture for 5-10 minutes. This will
loosen the film and brighten the silver.
4.
Immerse the end of the line into the soda solution. This will stop the action of the ac-
id.
5.
Use a Scotch Bright pad or steel wool to scrub off the remaining torch black.
6.
If the flux scale is particularly stubborn repeat the process.
7.
When finished, rinse thoroughly when done with water and dry the line before assem-
bling.
A.5.1 Alternate Cleaning Method
The following is an alternate procedure to clean the soldered transmission line. The
following materials are needed.
• Water and Hose
• Small Paint Brush
• Rubber Gloves
• Scotch Brite Pad or BBQ Grill Cleaning Pad With Handle
• Naval Jelly (or equivalent rust remover).
Warning
NAVAL JELLY CONTAINS PHOSPHORIC ACID AND CAN BE DANGEROUS IF IT
COMES IN CONTACT WITH SKIN OR EYES OR IF IT IS SWALLOWED. READ AND
FOLLOW THE PRECAUTIONS AND EMERGENCY PROCEDURES ON THE NAVAL
JELLY CONTAINER BEFORE USING.
1.
After soldering the flange, dip the end of the line into water or spray it with a hose un-
til it is cool.
Summary of Contents for Maxiva ULX
