Harris BMXDIGITAL 99-1200-0, Operation & Technical Manual

Page: 82 / 146

Revision C • 1/04
H A R R I S C O R P O R A T I O N
3-4
3 Operation
digital
SEND 1 and SEND 2
(not present on limited-feature modules)
This section has the on/off control, level, and signal routing controls
to feed the module’s audio to the Send 1 and Send 2 buses. The
controls are identical for each Send bus.
PRE F PRE F PRE F PRE F PRE FADER — ADER — ADER — ADER — ADER — When lit, the send audio feed is taken before the
module’s fader (thus adjusting the fader level does not affect the
send output level). When unlit, the send level is affected by the
module’s fader setting.
PRE SWIT PRE SWIT PRE SWIT PRE SWIT PRE SWITCH — CH — CH — CH — CH — When lit, the send audio is always available
(it is not affected by the module On/Off buttons). When unlit, the
send output follows the module’s on/off status.
R R R R Rotar otar otar otar otary y y y y V V V V Volume C olume C olume C olume C olume Con on on on ont r t r t r t r t rol — ol — ol — ol — ol — Sets the level of the module audio
feeding that send bus.
ON/OFF — ON/OFF — ON/OFF — ON/OFF — ON/OFF — When lit, connects the module to that send bus. If the
module is on (or if the PRE SWITCH button is lit) and the volume
control is turned up (and the module fader is up, if PRE FADER is
not lit), then audio is applied to the bus. When unlit, no audio
from this module is applied to that send bus.
UTILITY BUSES
(not present on limited-feature modules)
This section has the module controls for the four Utility buses:
UTL 1, UTL 2, UTL 3, and UTL 4.
UTL 1, UTL 2, UTL 3, UTL 4 — UTL 1, UTL 2, UTL 3, UTL 4 — UTL 1, UTL 2, UTL 3, UTL 4 — UTL 1, UTL 2, UTL 3, UTL 4 — UTL 1, UTL 2, UTL 3, UTL 4 — When lit, routes the module
audio to Utility bus 1, 2, 3, or 4. The module can be assigned to
any combination of buses. When the button is unlit, no audio is
fed to that Utility bus.
PRE F PRE F PRE F PRE F PRE FADER — ADER — ADER — ADER — ADER — When lit, the audio feed to that Utility bus is
taken before the module’s fader (thus adjusting the fader level does
not affect the level to the bus). When unlit, the feed level to the
Utility bus is controlled by the module’s fader setting.
PRE SWIT PRE SWIT PRE SWIT PRE SWIT PRE SWITCH — CH — CH — CH — CH — When lit, the audio feed to that Utility bus is
always active (it is not affected by the module On/Off buttons).
When unlit, the feed to the Utility bus follows the module’s on/off
status.
Both the Pre Fader Pre Fader Pre Fader Pre Fader Pre Fader and the Pre Switch Pre Switch Pre Switch Pre Switch Pre Switch buttons can be selected on
any Utility or Send Bus.
Universal Input, Telco/Codec & RLS Modules