Harris BMXDIGITAL 99-1200-0, Operation & Technical Manual

Page: 44 / 146

Revision C • 1/04
H A R R I S C O R P O R A T I O N
2-32
2 Installation
digital
RESET (SEE MANUAL)
RESET RESET RESET RESET RESET — — — — — This switch resets all operational parameters on all modules.
Typically, this switch is only used for test or servicing purposes only used for test or servicing purposes only used for test or servicing purposes only used for test or servicing purposes only used for test or servicing purposes and has
no normal operational use since this switch does not reset the DSP cards nor
the BMXdigital Server–it only resets the input module operational
parameters.
QUICK GUIDE TO THE SESSION MODULE
Four user connectors come standard on the Session module: one 10base-T connector (DATA) and
three 3-pin EXT. TIMER connectors. There are also three meter panel connectors, which are factory
connected. All connectors are hidden by the meter panel in normal operation.
INPUTS/OUTPUTS
DA DA
DA DA DAT
T
T T TA —
A —
A — A — A —
Connect a standard CAT-5 cable to this 10base-T connector to
tie the BMXdigital Server into a Local Area Network (LAN). See Chapter 4 for
more information on configuring and using the BMXdigital Server.
LOGIC OUTPUTS
EX EX
EX EX
EXT T
T T
T TIMER — TIMER —
TIMER — TIMER —
TIMER — Three 3-pin External Timer connectors are available to
reset external event timers. For more information, see page 2-33.
TO METER PANEL
LEGENDS — LEGENDS — LEGENDS — LEGENDS — LEGENDS — Factory harnessed connector that outputs the alphanumeric
meter names.
METERS — METERS — METERS — METERS — METERS — Factory harnessed connector that outputs the meter level
data.
TIMER / TIMER / TIMER / TIMER / TIMER / TB MIC — TB MIC — TB MIC — TB MIC — TB MIC — Factory harnessed connector that has the audio
from the meter panel-mounted talkback microphone and the timer control
signals from the Session module Start, Stop, Reset, and Hold buttons.