Harris BMXDIGITAL 99-1200-0, Operation & Technical Manual

Page: 46 / 146

Revision C • 1/04
H A R R I S C O R P O R A T I O N
2-34
2 Installation
digital
CONTROL ROOM MODULE CONNECTORS
Thirteen connectors come standard on each Control Room module: five 6-pin analog audio input
connectors, six 6-pin analog audio output connectors, one 14-pin logic connector, and one 8-pin logic
connector. The connectors are hidden by the meter panel in normal operation.
AUDIO INPUTS
EX EX EX EX EXT-1, T-1, T-1, T-1, T-1, EX EX EX EX EXT-2, T-2, T-2, T-2, T-2, EX EX EX EX EXT-3, T-3, T-3, T-3, T-3, EX EX EX EX EXT-4, T-4, T-4, T-4, T-4, CUE IN — CUE IN — CUE IN — CUE IN — CUE IN — These 6-pin analog inputs
accept stereo or mono signals from external monitor sources such as off-
air tuners, a synthetic air monitor, VistaMax monitor output, etc. When a
mono source is connected, parallel the signal to the left and right inputs.
AUDIO OUTPUTS
MONIT MONIT MONIT MONIT MONITOR, OR, OR, OR, OR, OPER OPER OPER OPER OPERA A A A AT T T T TOR, OR, OR, OR, OR, CO-HOST CO-HOST CO-HOST CO-HOST CO-HOST,,,,, GUEST GUEST GUEST GUEST GUEST,,,,, CUE CUE CUE CUE CUE,,,,, TALKB TALKB TALKB TALKB TALKBA A A A AC K C K C K C K C K
— — — — — The 6-pin analog outputs for the control room monitor speaker amplifier
(Monitor); three outputs for the headphone amplifiers for the board operator
(Operator), co-host or host (Co-host) and for one or more guests (Guest); a
Cue amplifier feed (Cue); and a separate Talk to Control Room output
(Talkback) for a powered Talkback monitor speaker or amplifier.
LOGIC I/O
L L
L L LOGIC —
OGIC —
OGIC — OGIC — OGIC — This 14-pin connector has four “relay” outputs (Control Room
warning, mute, dim, and talkback) and two remote inputs (Dim and
Mute). See pages 2-36 and 2-37 for details on these signals.
CUE CNTL — CUE CNTL —
CUE CNTL — CUE CNTL — CUE CNTL — This 8-pin connector has an external cue control input
See page 2-38 for details on this signal.
Right High (+)
Right Low (-)
Shield
Left High (+)
Left Low (-)
Shield
High (+)
Low (-)
Shield
Analog Inputs / Outputs - Stereo
3
2
1
6
5
4
(wire insertion end view)
Analog Inputs - Mono
High (+)
Low (-)
Shield
3
2
1
6
5
4
(wire insertion end view)