7/26/05
888-2523-001
2-35
WARNING: Disconnect primary power prior to servicing.
Section 2 Installation / Initial Turn-On
ATLAS Analogue
NOTE:
Exciter A is always factory installed as the lower unit, below the control panel.
The optional exciter B is installed as the top unit just below the RFU, above the
transmitter control panel (see layout photos on page 1-2).
2.13.3 RF Initial Turn ON
!
CAUTION:
THE TRANSMITTER SHOULD BE INITIALLY POWERED INTO THE TEST LOAD.
Check and Set the ALC (Automatic Level Control). Press POWER AMP, then PA
METERS. The ALC number that controls the power output level of the transmitter is
seen at the upper right corner. Press the transmitter Power up/down buttons (arrow-
shaped buttons) until the ALC number reads 80.
Figure 2-6 PA Meters Screen
Switch ON the two, four or eight PA circuit breakers (CB8 - CB1 depending on
transmitter model) on the mid deck in the rear of the transmitter.
Press the transmitter ON button.
Summary of Contents for ATLAS ANALOGUE
