Assembly
January 2002
Unit 00AL
35
In this step, the halyard swivel, feeder and torque tube are attached to the foil.
5
.ORSEMAN3TA,OK)NSTRUCTIONS
!FTERTHESWIVELANDTORQUETUBEHAVEBEENPLACEDONTHEWIRE
YOUMUSTINSTALLTHE.ORSEMANOR3TA,OKTERMINAL&OREASIER
INSTALLATIONPUSHTHEBOTTOMFOILCOMPLETELYOVERTHEBOTTOM
CONNECTORTOEXPOSEASMUCHWIREASPOSSIBLE!FTERTHETERMI
NALISATTACHEDSECURETHEBOTTOMFOILASDESCRIBEDIN3TEP
2OD)NSTRUCTIONS
!FTERTHESWIVELHASBEENATTACHEDPERTHEABOVEINSTRUCTIONS
YOUMUSTATTACHTHERODTERMINALTOTHEROD
Slip the halyard swivel onto the foil and up past the 1
5
/
8
"
(41 mm) gap in the foils.
The halyard swivel has a “top” and a “bottom” and must
be placed on the foil with the long hooked tang facing up.
Attach the feeder to the gap in the foils. Use blue Loctite
on the screw. The end of the feeder with the screw
should be at the bottom of the gap.
Slip the torque tube cap onto the foil, open end down.
Slip the drum assembly onto the foil until it stops. The
top of the torque tube will be 15" (380 mm) from the
bottom of the feeder.
./23%-!.34!,/+/22/$REFERTOSPECIAL
INSTRUCTIONSBELOWBEFOREPROCEEDING
4IP4HEFEEDERUSESAhLOOSEHINGEv0LACETHEHALFWITHTHEPIN
SOCKETSINTOPLACEONTHEEXPOSEDCONNECTORSLIPTHEHALFWITHTHE
PINSINTOTHESOCKETSANDSNAPITSHUT
4IP7HENPOSITIONEDCORRECTLYTHESMALL(ARKENLABELWILLBERIGHT
SIDEUP
4IP2UBBERBANDLINETOTHETORQUETUBETOKEEPOUTOFTHEWAY
Long Hooked
Tang Up
STOP