HanseLifter SDJ Series, Manual

Page: 35 / 251

Page 13 of 22
SDJ10 – Series Duplication, even in parts, is not permissible.
Valve fine adjustment
1.) Adjustment of the valve on the right-hand side: At first, bring the lever at the drawbar to the
lowermost position (lifting) and unscrew the adjustment screw from the valve. The same is fixed by a
locking nut seated on the adjustment screw. Now, it should be possible to pump up the platform floor
truck. Now you can set the lifting procedure by fine adjusting the valve.
2.) Bring the lever at the drawbar to the centre position (neutral) and slowly screw in the adjustment screw until
the platform floor truck does not lower and does not lift either. Fix this point by using the nut.
Warranty
Genuine parts and accessories
Please use genuine HanseLifter® parts for your HanseLifter® platform floor truck only. Installing spare parts
and accessories of other manufacturers is not checked and approved by us and, thus, may have adverse
effects on the properties of the device. The manufacturer shall not assume any liability for damages resulting
from the installation of non-genuine parts and accessories. Furthermore, the warranty will forfeit if spare parts or
accessories are installed in an unauthorised manner by third parties.
HanseLifter® recommends
®
products.
Tightening torques
Tightening torque (Nm)
Dimension
4.6 5.6 6.6 8.8
M 6 4-5 5-7 6-8 9-12
M 8 10-12 12-15 14-18 22-29
M 10 20-25 25-31 29-39 44-58
M 12 35-44 44-54 49-64 76-107
M 14 54-69 69-88 83-98 121-162
M 16 88-108 108-137 127-157 189-252
M 18 118-147 147-186 176-216 260-347
M 20 167-206 206-265 245-314 369-492
M 22 225-284 284-343 343-431 502-669
M 24 294-370 370-441 441-539 638-850
M 27 441-519 539-686 637-784 933-1244
M 30 529 - 666 666 - 833 784 - 980 1267 - 1689
M 36 882 - 1078 1098 - 1372 1323 - 1677 2214 - 2952
Table 4 Tightening torques
Note:
•
Use screws of strength class 8.8 for all load-carrying and important parts only.
•
The strength classes are listed in the table above