28
7.
Target Network ID
This is needed for our A-1519/1520 Scanning
targets and not used in this application.
8.
Calibration Factors - Vertical and
Horizontal Slope Offsets and Focal Length.
These are correction factors that are used for
another application and are not needed for
surface plate calibration.
9.
Ambient Light Frequency
– The
T-1297 Targets utilize an ambient light
correction feature that improves accuracy.
This requires that the target be set to the
existing electrical frequency. Normally the
U.S. is 60 Hz and Asia/Europe is 50 Hz
Note
– the target must be turned on and be paired
with the PC to change the frequency. Normally this
is set at the factory to match the country it is being
shipped to.
10.
Defined Targets
- You can set up multiple
targets if desired. The target names and modes
will appear in the
Defined Targets
area.
To select a target go to
Step 2
and choose from
the
Target
dropdown list where up to 10 target
setups may be stored.
Summary of Contents for L-703SP
Page 1: ......
Page 54: ...50 An example on how to do the Math to get the exact flatness values...
Page 55: ...51 Plane6 Sample Report...