HAKO Citymaster 650, Operating Manual

Page: 75 / 190

02-147015-00-00.fm
75
Use
Adjustable upper link (optional)
The adjustable upper link Fig. 66-A is provided for the fine adjustment of
attachments and for simplified take-up of attachments with conventional
A-frames type 0. Loosen the nut Fig. 66-B and adjust the middle section
with a suitable tool to the required length. Then secure with the nut
Fig. 66-B .
•
Turn the middle section clockwise = the front tool carrier inclines to the
front
•
Turn the middle section counter-clockwise = the front tool carrier
inclines to the back
Maximum (I) : The spindle touches the edges of the long elongated hole.
Minimum (II) : Both spindles are flush.
Standard length (III) : The spindle touches the edges of the short elon-
gated hole.
Weight holder (optional)
Weight counterbalance Fig. 67-A at the tail is required for all heavy front
attachments. A weight holder is optionally available. A maximum of six
counterweights Fig. 67-C (17 kg each) can be hooked into the bars
Fig. 67-B .
Lift system tipper body (optional)
With the optional lift system tipper body, additional controls for raising or
lowering the tipper body are located on the left side of the rear wagon.
•
Raise tipper body: Press the button Fig. 68-A and the button Fig. 68-B
simultaneously
•
Lower tipper body: Press the button Fig. 68-A and the button Fig. 68-C
simultaneously
Fig. 66:
A B
II
I
III
Note
When the sweeping system is used, adjustment to position III
Fig. 66 is required for correct operation of the sweeping unit.
Fig. 67:
A B C
A
Fig. 68:
B
C
Danger
Risk of crushing! When carrying out work on the tipper body,
always operate the controls in two-handed operation.