12
Introduction
96-8000 rev R June 2007
Memory Lock Key Switch - This switch prevent the operator from editing programs and from altering settings
when turned to the locked position. The following describes the hierarchy of locks:
Key switch locks Settings and all programs.
Setting 7 locks parameters.
Setting 8 locks all programs.
Setting 23 locks 9xxx programs.
Setting 119 locks offsets.
Setting 120 locks macro variables.
Second Home Button - This button will rapid all axes to the coordinates specified in work Offset G129. The
sequence is as follows: First, the Z axis is returned to machine zero, then the X and Y axes are moved, then
the Z axis is moved to its second home position. This feature will work in any mode except DNC.
Work Light Switch - This switch will turn on the work light inside of the machine.
Keyboard Beeper - Located at the top of the parts tray. The volume can be adjusted by turning the cover.
F
UNCTION
K
EYS
F1- F4 Keys - These buttons have different functions depending upon which mode of operation you are in. For
example, F1-F4 will cause a different action in Editing mode, than Program mode, than Offset mode. See the
specific mode section for further descriptions and examples.
Tool Offset Meas (Tool Offset Measure) - Used to record tool length offsets during part setup.
Next Tool - Used to select the next tool from the tool changer (usually used during part setup).
Tool Release - Releases the tool from the spindle when in MDI mode, zero return mode, or handle jog mode.
Part Zero Set - Used to automatically set work coordinate offsets during part setup (see Setting Offsets in the
Operation section).
J
OG
K
EYS
Chip FWD (Chip Auger Forward) - Starts optional chip auger in the “Forward” direction, moving chips out of the
machine.
Chip Stop (Chip Auger Stop) - Stops auger movement.
Chip REV (Chip Auger Reverse) - Starts the optional chip auger in the “Reverse” direction, which is useful in
clearing jams and debris from auger.
X/-X, Y/-Y, Z/-Z, A/-A and B/-B (axis keys)- Allows the operator to manually jog axis by holding down the
individual button or pressing the desired axes and using the jog handle.
Jog Lock - Works with the axes buttons. Press jog lock and then an axis button and the axis will move to
maximum travel or until jog lock is pressed again.
CLNT Up (Coolant Up) - Moves the optional Programmable Coolant (P-Cool) nozzle up.
CLNT Down (Coolant Down) - Moves the optional P-Cool nozzle down.
AUX CLNT (Auxiliary Coolant) - Pressing this key while in MDI mode will turn on the optional Through the
Spindle Coolant (TSC) system; pressing it a second time will turn off TSC.
Summary of Contents for Mill
