1 6 5
G Codes
96-8000 rev R June 2007
A specific X, Y, Z, A, B position must be programmed before the canned cycle is commanded. This position is used
as the “Initial Start position”.
G166 5-Axis Bore and Stop Canned Cycle (Group 09)
E
Specifies the distance from the start position to the bottom of the hole
F
Feedrate in inches (mm) per minute
L
Number of repeats
A
A-axis tool starting position
B
B-axis tool starting position
X
X-axis tool starting position
Y
Y-axis tool starting position
Z
Z-axis tool starting position
G166
5
-Axis Bore Stop Canned Cycle
G166
5
-Axis Bore Stop Canned Cycle
E
G98 Start
Position
G98 / G99
E
Start Position
G99 Rapid Plane
Z Axis position
between holes
Feed
Rapid Move
Begin or end
of Stroke
A specific X, Y, Z, A, B position must be programmed before the canned cycle is commanded. This position is used
as the “Initial Start position”.
G169 5-Axis Bore and Dwell Canned Cycle (Group 09)
E
Specifies the distance from the start position to the bottom of the hole
F
Feedrate in inches (mm) per minute
L
Number of repeats
P
The dwell time at the bottom of the hole
A
A-axis tool starting position
B
B-axis tool starting position
X
X-axis tool starting position
Y
Y-axis tool starting position
Z
Z-axis tool starting position
G169
5
-Axis Bore and Dwell Canned Cycle
G169
5
-Axis Bore and Dwell Canned Cycle
E
G98 Start
Position
G98 / G99
E
Start Position
G99 Rapid Plane
Z Axis position
between holes
Feed
Rapid Move
Begin or end
of Stroke
Summary of Contents for Mill
