Connecting with Cables
The Visutron 900
Touch
can connect to multiple Pro-
jectors, Lensmeters, and Autorefractors easily with a
wired connection. Refer to the instructions below to
connect instruments with a cable.
1. Tap
Setting
s, located at the top right of the
Controller screen. Refer to Figure IS-06
2. Tap
Ports
in the Settings menu.
3. In the Port Selection panel, tap the
port being configured (e.g., Projector,
Instrument 1, etc). Refer to Figure IS-
07.
4. In the Port Settings panel, select the
device being connected from the drop-
down menu. Refer to Figure IS-07.
5. Set the Connection Type to
Cable
.
Refer to Figure IS-07.
6. If storing or transferring of data is
needed, check the corresponding
boxes. Refer to the
Daisy Chaining
Multiple Visutron 900 Touch’s
section
of this manual for more information on
these two options.
7. If available, set the serial
communication parameters to match
the settings on the device being
connected.
8. Tap
Apply
. “Connected” should appear
in the top right. Refer to Figure IS-08.
Instrument Setup
(continued)
Figure IS-06, Settings
Figure IS-07, Port Settings Screen
Figure IS-08, Port Settings Screen
13
16243-101 Rev. G
Summary of Contents for VISUTRON 900 Touch
Page 1: ...VISUTRON 900 Touch User s Guide ...
Page 85: ...Notes 85 16243 101 Rev G ...
Page 86: ...Notes 86 16243 101 Rev G ...
Page 87: ...Notes 87 16243 101 Rev G ...
