Connecting the Visutron 900
Touch
System
WARNING:
APPLY RATED INPUT VOLTAGE TO THE UNIT AS INDICATED ON THE DATA PLATE TO PREVENT
DAMAGE TO THE INSTRUMENT AND/OR INJURY TO THE OPERATOR OR PATIENT.
WARNING:
CAREFULLY ARRANGE THE CABLES FOR THE UNIT AND ACCESSORIES, SO THE CABLES DO NOT
PRESENT A TRIPPING HAZARD TO THE EXAMINER OR A DANGER TO THE PATIENT.
WARNING:
POSITION THIS INSTRUMENT SO THE PLUG IS EASILY ACCESSIBLE.
WARNING:
DO NOT PLUG IN THE CENTRAL UNIT UNTIL THE VISUTRON 900 TOUCH SYSTEM IS FULLY SETUP.
The basic system setup contains three components programmed to interact with each other: the
Phoroptor Head, the Central Unit, and the Controller. The Central Unit directs communication between
the Phoroptor Head, Controller, and other pre-test devices, while the Controller acts as the user interface
and controls the Phoroptor Head and the Input/Output of data.
The Visutron 900
Touch
is also designed to communicate with Reichert and other manufacturers acuity
systems.
External devices, including digital acuity systems, projectors, Lensmeters, Auto Refractors, printers, and
computers are connected using serial cables or Bluetooth wireless serial adapters.
Note:
Ensure that the pre-test equipment being interfaced is compatible. Refer to
Appendix A
for a
complete list of external devices that communicate with the Visutron 900
Touch
.
Please refer to the Connection Diagram below for plug and cable layout.
Phoroptor Head
Projector or Digital Acuity System
Controller
Central Unit
Power
EMR
Figure IS-02, Connection Diagram
Instrument Setup
(continued)
11
16243-101 Rev. G
Summary of Contents for VISUTRON 900 Touch
Page 1: ...VISUTRON 900 Touch User s Guide ...
Page 85: ...Notes 85 16243 101 Rev G ...
Page 86: ...Notes 86 16243 101 Rev G ...
Page 87: ...Notes 87 16243 101 Rev G ...
