maintenance & safety inspections
file: n:\article\cos14310m5-v1.04hpc-en\20080901_cos14310m5-v1.04hpc-en_manual_h-p-cosmos_running_machine.doc
© 2008 h/p/cosmos sports & medical gmbh [email protected] created 01.09.2008 printed 08.10.2008 page: 108 of 176
[7.D4]
Devices with UserTerminal & automatic oil-pump (models "r" for cycle & wheelchair)
Running machines which are designed for cycle and
wheelchair use are equipped with an automatic
controlled oil-pump and an oil-tank.
The oil-tank is located in the external control unit of the
device below at the left side (At device up to the
construction year 2002 and without external control unit
the oil-tank is located at the rear position of the machine,
close to the drive engine).
The picture shows the oil-pump with the valve-cock (red
arrow). With the valve-cock the valve for running-deck
lubrication has to be positioned horizontally or vertically,
depending on the application on the running surface
(see illustrations next page). The valve-cock always
must be rotated up to the mechanical stop. Intermediate
positions ar not allowed and can result in serious
damages of the machine.
In particular at running machines designed for cycle and wheelchair application, the correct quantity amd quality of
oil is extremely important. Thus at those models a lubrication test (tissue-test) according the instruction (available
from h/p/cosmos) must be performed in the course of the obligatory yearly maintenance. The test must be sent
back to h/p/cosmos afterwards for evaluation purposes.
Cooperation and inspection obligation of the user:
Especially at treadmills designed for cycle and wheelchair application (all types of point loads on the running
surface or the running belt) a cooperation and inspection obligation of the user is due. The lubrication quantity and
quality between running belt and running surface needs to be observed and if necessary corrected accordingly.
See separate instruction “lubricant test”.
N
Warning! Only special-treadmills with special labelling are adapted for cycling and
wheelchair applications! At treadmills which are not designed for cycling and wheelchair
use or for use with spikes or ski sticks, those applications will result in serious damages
of the treadmill.
N
Due to environmental influences, interior climate and type of application (for example
frequent short-run operation or infrequent long-run operation, etc.) the required
automatic oil-setting of the treadmill can deviate extensively from the factory setting.
N
In case the required lubrication quantity and quality is not assured due to missing
inspections of the user and/or due to missing maintenance through authorized
h/p/cosmos service-technicians, early damages of running belt and running surface can
occur and warranty will expire.
