GTCO CalComp Super L VI Series, User Manual

Page: 31 / 48

Super L VI 31
 Decimal: Defines whether the period character (hex 2E) is included in the ASCII output
report between the units and tenths digits. This option is available only in
Summagraphics formats. Choices are: Include or Exclude.
 Return: Defines whether the Carriage Return (CR) character (hex 0D) is included in the
ASCII output report as a terminator. This option is available in GTCO and
Summagraphics formats. Choices are: Include or Exclude.

Line Feed: Defines whether the Line Feed (LF) character (hex 0A) is included in the
ASCII output report as a terminator. This option is available in GTCO, CalComp and
Summagraphics formats. Choices are: Include or Exclude.
Mode Options
 Mode: Defines how output reports are sent from the digitizer. Choices are: Point, Line,
Continuous, Line Incremental or Continuous Incremental.
 Rate: Determines how fast output reports will be transmitted from the digitizer. Choices
are: 12, 50 or 100 reports per second.
 Resolution: The smallest reported value returned by the digitizer. Choices are: 1000 lpi,
2000 lpi, 4000 lpi, 40 lpmm, 100 lpmm or 150 lpmm.
Using the Tablet Configuration Utilities
If your application is not represented in the SuperSet Menu and does not have a SuperSet Code
or if a different configuration is required, you can use the Tablet Configuration Utilities to
structure the Super L VI. The Tablet Configuration Utilities replace the 24 switches that were
associated with older GTCO CalComp digitizers and the Custom Configuration Menu Card used
with the Super L II Plus.
To Configure the Super L VI with the Tablet Configuration Utilities:
1. Make sure the Super L VI is plugged into a Serial Port, powered on and all the tablet
drivers have been uninstalled or disabled.
2. Install the Tablet Configuration Utilities from our Website www.gtcocalcomp.com .
3. After installation is complete, run the
Tablet Configuration Utilities
from the Programs
list under GTCO CalComp TCU.