GTCO CalComp Super L VI Series, User Manual

Page: 10 / 48

Super L VI 10
2. Turn the power switch on. The green Indicator Light will begin blinking and the digitizer
will beep four short tones, indicating it has power. See the
Super L VI Tones
section for
a complete table of the Super L VI tones.
NOTE: Power is supplied through the USB port. No additional power source is needed for this
installation.
QuikRuler III™ Connection
The Super L VI has a connection socket for the QuikRuler III. The QuikRuler III is a portable
measuring system that quickly and accurately automates blueprint takeoff and drawing
measurement processes. Contact GTCO CalComp Sales for price and availability.
Transducer Connection
1. If you are using a corded transducer, connect the cursor or pen to the appropriate jack
on the digitizer’s Connector Panel. The connector is keyed and will fit only the correct
jack. Do not force it.
Optional RS-232 Serial Connection
1. Connect the RS-232 serial cable to the serial jack on the Connector Panel. The
connector is keyed and will fit only the correct jack. Do not force it. Attach the 9-pin
connector of the serial cable to the serial port on your computer.
2. Plug the power supply into an AC outlet. Connect the power supply to the appropriate
jack on the Super L VI Connector Panel. Turn the power switch on. The green
Indicator Light will begin blinking and the digitizer will beep four short tones (see the
Super L VI Tones
section for a complete table of Super L VI tones), indicating it has
power.