GTC REVPAD, Manual

Page: 55 / 91

49
Customizing your REVPAD
from Patch Slot to Patch Slot and then use the Navigation Roller to set the Patch.
Note: You may define three Patch Favorite sets. However, you cannot configure a Patch Favorite set unless it has been assigned to
a Touchpad Control Button.
5. To use your Patch Favorites while you are playing, press Touchpad Control Button 1 and then the segment on your Touchpad
assigned to the Patch you wish to use. In this case, pressing segment 1 on the Touchpad will invoke Patch 01A.
If you decide to reduce the number of active segments on the Touchpad from 6 to 2 or 4, the last four or two selections are hidden. If
you return to 6 segments, REVPAD remembers the previous favorites.
Single Mode
Single mode gives you the ability to toggle individual effects in the active Patch off or on by pressing a Touchpad Control Button and
then tapping regions of the Touchpad.
Follow the procedure below to set up REVPAD system to use Single mode.
1. Assign Single to a Control Button or Control Button pair on the Touchpad. See “Touchpad Control Button Assignment” on page
65 for more information.
2. Each Touchpad segment is automatically assigned to the first six effects in the active Patch. Activate Single mode by pressing the
assigned Control Button or Control Button pair. The Pedal LED on the base unit front panel is illuminated. See “Status and Mode
LEDs” on page 22 for more information.
3. Tap the Segment representing an effect on the Touchpad to bypass that effect. The bypassed effect will be shown as “BYP” in the
REVPAD’s main display. To toggle an effect back on, tap the respective Touchpad Segment again.
Note: If you have selected
Select Only
in Pad Settings for Single mode, you remain in Single mode when you tap the
Touchpad to bypass or activate an effect. The Pedal LED continues to be illuminated. If you have selected
Select and Play
,