Installation & User Manual – Oncam C-12 Series
©
Oncam Global Group AG, 2021. All rights reserved.
164
Category
Event Trigger
Name
Description
Configuration/Audio
Output Configuration Media Service
This is like Configuration/Audio Decoder but is
included for Profile S conformance.
Configuration/Audio
Source Configuration Media Service
This generates an event when
Audio
Source
is changed. Outdoor Plus camera supports
only one audio source.
Configuration/Video
Output Configuration Media Service
The Camera does not generate this event.
Configuration/Video
Source Configuration Media Service
This event occurs when the
Video
Source
is
changed. Two video source modes are
supported, 50Hz and 60Hz. This is used to
indicate a change in the frequency. Changing
frequency to 50Hz will support up to a
maximum 50fps and 60Hz supports up to
60fps.
Device / Hardware
Failure
Storage Failure
The
Storage
Failure
event is generated when
the camera’s MicroSD card is full. In addition
to the event, the camera’s Status LED will turn
red to indicate the storage is full.
Temperature
Critical
This event monitors the camera temperature
and generates an event if camera CPU
reaches a threshold of 85 degrees Celsius,
considered to be
Temperature
Critical
. This
event is especially useful when the camera is
running in very hot environments.
Device / Operations
Mode
Shutdown
Initiated
The device generates a
Shutdown
Initiated
event right before reboot. This can occur when
the device is performing a reset or firmware
upgrade. This is useful for clients connected to
the camera to monitor if the camera is
performing shutdown.
Upload Initiated
This event is generated when an
Upload
is
Initiated
. This event precedes the
Upload
Status
event. This is used currently to indicate
upload status start.
Device / Trigger
Digital Input
When the camera detects a change in a
Digital
Input
, it triggers this event. It includes
information about the token of the digital input
and the current state of the digital input, open
or closed.
Relay
When the camera generates an output over
the
Relay
switch (Digital Output) this event is
generated. It includes information about the
relay token and the status of the relay.
Media
Configuration
Changed
This is like Configuration / Audio Encoder but
is included for Profile T conformance.
Profile Changed
This is like Configuration / Profile but is
included for Profile T conformance.
Monitor / Active
Sessions
Audio Decoder
This event is generated alongside Active
Connections. When a client connects to the
camera over RTSP stream and the profile
requested includes
Audio
Decoder
, this event
is generated. It includes information about the
audio decoder token.
Audio Encoder
This event is generated alongside Active
Connections. When a client connects to the
camera over RTSP stream and the profile