Settings
ķ
10
➡
Tuning the TV set to the recorder
The TV set receives programmes from different sta-
tions transmitted on certain channel numbers.
The recorder also transmits on this type of channel
(between channels 21 (frequency 471 MHz) and
channel 69 (frequency 855 MHz).
The factory setting is channel 36.
The recorder “searches” for a free channel and
shows the channel number or frequency in the
display.
This channel/frequency must then be set on the TV
set.
Ń
!
This adjustment is not necessary if the recorder
and the TV set are connected with a EURO-AV cable
(see chapter “Connecting” on page 5).
If necessary, switch the recorder’s transmitter off
to prevent picture interference, see chapter on
page 11.
❒
Preparation
Switch the TV set on.
Select the programme position for the video
recorder on the TV set (AV programme position).
❒
Tuning
Hold down the
›
CLEAR
button on the remote
control (for approx. 6 seconds).
Hold the
Q
button on the remote control down
(for approx. 6 seconds).
– The recorder searches for a free channel and
shows it in the display on the recorder.
If you want to adjust the frequency press the
E
button on the remote control. Switch back to the
channel setting using the
F
button.
Enter and store the channel number/frequency on
the TV set (see TV operating instructions).
– A “test picture” will appear on the TV screen
which is transmitted by the recorder.
GRUNDIG CTI TEST PATTERN
No reception of Programme 01
GRUNDIG
PATTERN
3
Ǻ
2
1
2
1
Ń
!
If the “test picture” quality is good, store the setting
with the
G
button on the remote control and end
using the
‚
on the recorder.
Ń
!
If the test picture quality is poor or has deteriorated
for one or more TV stations on your TV set, switch
the recorder off by pressing the
‚
button on the
recorder twice. Check the TV stations on the TV set
again.
If the problem only occurs when the recorder is
switched on, proceed as described in the chapter
“Improving the picture quality” on the next page.
❒
Setting for operation with a 100 Hz TV set
If the recorder is connected to a TV set with 100 Hz-
technology, and if the test picture “jumps” or
“shakes”, the recorder should be adjusted.
Press the
›
CODE
button, the numbered buttons
8 5 4 7
and the
G
button on the remote
control one after the other.
– Brief display on the recorder: »
ON
«.
If the recorder is connected to a standard 50 Hz TV
set after this adjustment has been carried out, press
the
›
CODE
button, the numbered buttons
8 5 4 6
and the
G
button one after the
other.
– Brief display on the recorder: »
OFF
«.
Ǻ
1
Summary of Contents for GV 740 HiFi
Page 1: ...VIDEORECORDER GV 740 HiFi...
