Model G0854 (Mfd. Since 08/18)
-53-
Adjusting
Edgebanding Coil
Limit Switch
The edgebanding coil limit switch (see
Figure 75)
signals the pneumatic end trimmer guillotine to
move into position and the pneumatic edgeband-
ing coil guillotine to activate. The switch is factory
set, and should not require routine adjustment.
However, after prolonged use, or if edgebanding
results are unsatisfactory, the switch may need
adjustment.
To adjust edgebanding coil limit switch:
1. DISCONNECT MACHINE FROM POWER
AND AIR!
2. Unlock and open panel feeder.
3. Loosen adjustment screws (see Figure 75).
— If guillotine leaves too little excess edge-
banding, move switch toward infeed table,
then retighten adjustment screws.
— If guillotine leaves too much excess edge-
banding, move switch toward outfeed
table, then retighten adjustment screws.
When the leading edge of the workpiece triggers
the switch, the end trimmer guillotine moves into
cut position. When the workpiece passes over
and releases the switch, the edgebanding coil
guillotine activates and the blade severs the edge-
banding from the coil, leaving some excess that is
then trimmed flush by the end trimmer guillotine.
If the edgebanding coil guillotine leaves too much
or too little excess edgebanding, you will need to
adjust the switch.
Figure 75. Location of guillotine limit switch and
adjustment screws.
Adjustment
Screws
Guillotine
Switch
Adjusting Edgebanding Coil Limit Switch
Item(s) Needed
Qty
Hex Wrench 3mm .............................................. 1
Summary of Contents for G0854
Page 96: ......
