-56-
Model G0854 (Mfd. Since 08/18)
7. Open rear access cover.
8. Loosen jam nut shown in Figure 80.
9. Rotate pressure roller adjustment bolt shown
in
Figure 80.
— Rotate bolt clockwise to move pressure
roller away from workpiece and reduce
pressure.
— Rotate bolt counterclockwise to move
pressure roller toward workpiece and
increase pressure.
Figure 80. Pressure roller adjustment
components (viewed from rear of machine).
10. Repeat Steps 6 & 9 until satisfied with adjust-
ment, then retighten jam nut from
Step 7 to
secure setting, and close rear access door.
11. Run a test piece of the same material and
thickness as your intended workpiece through
edgebander to verify satisfactory results. If
necessary, repeat
Steps 2–11.
Replacing Flush
Trimmer Drive Belt
The flush trimming motor transfers power through
a serpentine drive belt (see
Figure 81). The
belt is tensioned automatically by the weight
of the motor and does not require adjustment.
However, if it becomes worn, cracked, frayed,
broken, or otherwise damaged in any way, you
will need to replace it with a new one (
Grizzly
Part #P08540627).
Replacing Flush Trimmer Belt
Item(s) Needed
Qty
Hex Wrench 5mm .............................................. 1
Wood Block 4" x 4" x 7" .................................... 1
To replace flush trimmer drive belt:
1. DISCONNECT MACHINE FROM POWER
AND AIR!
2. Lower panel feeder all the way (refer to
Page 34).
Figure 81. Location of flush trimmer drive belt.
Drive
Belt
Pressure
Roller
Adjustment
Bolt
Jam Nut
Adjustable
Pressure
Roller
Summary of Contents for G0854
Page 96: ......
