Model G0854 (Mfd. Since 08/18)
-51-
Removing/Changing
Glue
If your edgebanding operation requires a different
type of glue, or if the glue becomes contaminated
with debris, you will need to remove the old glue
and replace it with new glue pellets.
Note: Glue pot is Teflon-coated. Do not scratch
surface when servicing.
To remove/change glue:
1. Turn machine OFF and wait for glue pot to
completely cool.
2. Turn machine ON and wait for glue pot to
reach 80°–90° C.
3. Use wood stick (approximately 6" x 1" x
1
⁄
2
")
to peel up one side of glue, as shown in
Figure 70.
4. Use pliers to grip peeled up portion of glue
and pull block of glue out of glue pot (see
Figure 71).
Note: Be careful not to scratch glue pot sur-
face.
5. Turn machine OFF, and allow glue pot to
completely cool.
6. Clean any remaining glue and debris from
bottom and sides of glue pot.
7. Carefully add glue pellets until they reach
3
⁄
4
"
(2cm) below top of glue pot.
8. Turn machine ON and allow glue pot to reach
operating temperature.
9. When glue pellets are completely melted,
check glue level and, if necessary, add prop-
er amount of glue (refer to
Page 34 for more
information).
Item(s) Needed
Qty
Wood Stick Approximately 6" x 1" x
1
⁄
2
" ............ 1
Pliers .................................................................. 1
Glue Pellets ....................................... As Needed
Figure 71. Using pliers to remove block of glue
from glue pot.
Removing/Changing Glue
Figure 70. Using wood stick to peel glue away
from glue pot for glue removal.
At 80°–90°C, Glue Peels
Away from Glue Pot
Summary of Contents for G0854
Page 96: ......
