Model G0854 (Mfd. Since 08/18)
-35-
Using Infeed Fence Stop
The infeed fence stop allows you to quickly and
easily set the infeed fence position without hav-
ing to use the scale. It is particularly useful when
switching back and forth between different edge-
banding thicknesses, or when the thickness of
the edgebanding cannot be expressed in whole
millimeters.
With this method, you place a scrap piece of
the edgebanding you intend to use between the
stop bolt and stop plate (see
Figure 44), then
adjust the fence until the stop plate presses firmly
against the scrap piece.
Note: For best results, the infeed fence stop
should be periodically checked for accuracy and, if
necessary, calibrated (see
Checking/Calibrating
Infeed Fence Stop on Page 50 for details).
To set infeed fence position using stop:
1. Cut a 1"–3" long section from edgebanding
you intend to use.
2. Loosen infeed fence adjustment lock lever,
then rotate knurled cylinder to create a
gap between stop plate and stop bolt (see
Figure 44).
3. Place scrap piece from Step 1 between stop
bolt and stop plate, as shown in
Figure 44.
Figure 44. Using infeed fence stop to set infeed
fence position.
4. Rotate knurled cylinder until stop plate press-
es firmly against scrap piece, then tighten
infeed fence lock lever to secure setting.
Infeed Fence Position
Setting Infeed Fence
Position
The infeed fence position is set according to the
edgebanding thickness.
There are two methods for setting the infeed fence
position: 1) using the infeed fence scale, and 2)
using the infeed fence stop (see
Figure 43).
Use whichever method best suits your needs and
situation.
Figure 43. Infeed fence adjustment components.
The numbers on the infeed scale correspond to
the edgebanding thickness (in millimeters). When
using the infeed scale, simply adjust the fence
until the scale indicates the correct edgebanding
thickness.
To set infeed fence position using scale:
1. Carefully measure thickness of edgebanding
to be used.
2. Loosen infeed fence adjustment lock lever,
rotate knurled cylinder until number indicating
thickness of edgebanding aligns with mark
on scale (see
Figure 43), then retighten lock
lever.
Using Infeed Fence Scale
Infeed Fence
Lock Lever
Knurled
Cylinder
Scale
Fence Stop
Stop
Plate
Stop
Bolt
Section
of Edgebanding
Summary of Contents for G0854
Page 96: ......
