LCX603-UM-651-9370
2-77
2 Setup
(4) Open the separator suppression unit (Step 1) and pull out the media from the separator unit (Step 2).
Cut the adhesive area of the media approximately 100 mm from the posterior end (Step 3).
Peel the adhesive section of the media (Step 4).
Pull the backing media only out from the media exit area.
Pull the adhesive part of media out from the separator suppression unit (Step 6).
Separator suppression unit
Pull the media
out from here
Separator arm
Cut the adhesive section only
at approximately 100 mm from
the posterior end of the media.
Backing
sheet
Step 3
Step 2
Pull the adhesive section
only out from here
Step 4
Detach the sdhesive
section only
Step 6
Step 5
Step 1
Pull the backing media
only out from here.
(5) Put the adhesive part of media to the bobbin while pulling the backing part of media as shown in the
picture below.
Step 2
Put the adhesive part of
media to the bobbin.
Step 1
Pull out the backing
part of media.
Summary of Contents for LABELROBO LCX603
Page 2: ......
