LCX603-UM-651-9370
2-35
2 Setup
(23) The following message is displayed.
Press the ENTER Key, this is confirming the laminate was set.
Press the ENTER Key, even if the laminate was not set.
L04:Confirm. Was the
laminate install?
YES:ENTER
Above menu will not be displayed when the laminate bobbin was setting to the laminate holder.
Above menu will not be displayed when the laminate function setting was setting to OFF.
(24) The following message is displayed. Don’t press the ENTER Key until the dancer rollers are installed
to the LCX603.
L04:Confirm. Was the
dancer roller set?
Initialize will
start. YES:ENTER
(25) Install dancer roller 1 to the LCX603 as shown in the picture below.
Insert both sides of the dancer roller into the slot that accepts it.
Install dancer roller 1 to the side with the red mark.
Dancer roller 1
(Has a red ring mark on both side)
Red mark
There are two kinds of dancer rollers, don’t install them to wrong position.
Dancer roller 1
There are red rings on both sides.
Used in between the press roller and cutter uint.
There is no red ring.
Used in between the cutter unit
and the separator unit.
Dancer roller 2
Red ring
Summary of Contents for LABELROBO LCX603
Page 2: ......