LCX603-UM-651-9370
3-20
3 Installing the Printer Driver
Vectorize Raster Lines Settings
......................................... The vectorize settings can be set only during Method 2 and 3.
Perform fine line vectorizing
.............................. Vectorizing is performed after the data has been converted
to fine lines.
If the lines to be vectorized are too wide, the driver will not
recognize them as Cutlines and they will not be output. If
you want to output such lines as Cutlines, check this box.
Use this option with applications where fine lines cannot be
output.
Line Length ........... Specifies the minimum length of the cutlines to be output.
The driver ignores lines which are shorter than this length,
and does not output them.
The settings range is 0.1 mm - 5.0 mm.
Treat as same line if gap is
.............................. Specifies the dot gap, which is acceptable as same line
data.
Depending on the application used, gaps can occur in an
output raster line, making it difficult to determine whether
the segments are from the same line or separate lines. This
option fills in the dots and enables output as one continuous
line. However, if this value is too large, separate lines may
be treated as one continuous line.
The settings range is from 0 to 20 dots.
Restore Defaults ............... Resets the settings to their original values.
Summary of Contents for LABELROBO LCX603
Page 2: ......
