LCX603-UM-651-9370
2-19
2 Setup
2.9.2 Installing the cutter pen to the LCX603
The tools (cutter pen) are set in this device.
When installing the cutter pen in the tool holder, fully insert the cutter pen section in the below order
until it bumps into the top side of the tool holder. After the cutter pen is installed, tighten the screw.
Furthermore, do not touch the pen tip when the power has been turned on or during operation.
When handling the cutter blades, take full care not to cut your hands. When pushing up
the tool holder, take full care not to injure your fingers on the cutter blades.
(1) Loosen the tool holder screw.
(2) While pushing up the tool holder, fully insert the cutter pen section until it bumps into the top side of
the tool holder. Set the bracket to hold tool to cover the flange section of the cutter pen.
Flange
Bracket to hold tool
Flange
Bracket to hold tool
(3) When the cutter pen is set, set the bracket to hold tool to cover the flange section and tighten the
screw.
Flange
Bracket to hold tool
Correct position of bracket
Correct position of bracket
Incorrect position of bracket
Good
Bad
Summary of Contents for LABELROBO LCX603
Page 2: ......
