Device Description HG G-71915ZA | English, Revision 01 | Date: 09.09.2021
6
Chapter 1 – About this Device Description
1
About this Device Description
1.1 Validity
This device description applies to the transponder antenna HG G-71915ZA.
It comprises information on correct mounting, electrical installation, commissioning,
operation, maintenance and troubleshooting.
This device description refers to devices from Firmware 1.00 (see Figure 15 on page
31).
1.1.1 Target group
This device description is intended for
developers, manufacturers or operators of systems who want to position mov
-
ing parts or automatically guide vehicles with the support of the transponder
antenna HG G-71915ZA,
any technical staff of a manufacturer planning to integrate the transponder
antenna into an Automated Guided Vehicle (AGV) or to use the RFID-based
position detection and identification function in another way,
qualified persons who integrate the transponder antenna into a vehicle or
mobile robot, put it into operation for the first time or configure it.
1.1.2 Additional Applicable Documents
This device description does not provide any information concerning the operation
of the higher-level system, e.g. an Automated Guided Vehicle (AGV), in which the
transponder antenna is integrated.
Do not put the transponder antenna into operation until you have received the
manual of the manufacturer or the system operator and have read and
understood them.
Supplementary documents are available on request or directly from
our website. The QR code on the right takes you to our homepage
. The following links refer to specific product
pages.
–
Disc transponder HW DEV00095/00098
http://www.goetting-agv.com/components/00095
–
Rod transponder HG G-71325XA
http://www.goetting-agv.com/components/71325
–
Transponder programming device HG G-81840ZA
http://www.goetting-agv.com/components/81840
–
Connection box M12/USB HG G-20960ZA
