2
Goodmans Product Information Helpline 0870 873 0080
Important safeguards
For you own safety read following instructions carefully before attempting to connect this clock radio to the mains .
Main Supply:230V, 50Hz ,AC only
This unit is designed to operate on a 230V,50Hz supply only. Connecting it to other power sources may damage it. Ensure that the
supply corresponds to the information on the rating tabel on the bottom of the unit.
This component system may be fitted with a non-rewireable plug. If it is necessary to change the fuse in a non-rewireable plug the
fuse cover must be refitted. If the fuse cover becomes lost or damaged, the plug must not be used until a replacement , available
from the manufacturer, is obtained. It is important that the colour of the replacement fuse cover corresponds with the colour marking
on the base of the plug.
If the plug needs to be changed because it is not suitable for your socket or becomes damaged. It should be cut off and an
appropriate plug fitted following the wiring instructions below. The plug must then be disposed of safety, as insertion into a 13A
socket is likely to cause an electricity hazard.
This symbol means that this unit is double insulated.
An earth connection is not required.
DANGER
LASER SAFETY
CAUTION
CAUTION : USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER
THAN SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE, INVISIBLE LASER
RADIATION WHEN OPEN AND INTERLOCK FAILED OR DEFEATED , AVOID DIRECT EXPOSURE TO
BEAM.
This unit employs a laser. Only a qualified service person should remove the cover or attempt to service.
To prevent electric shock, disconnect from the mains before removing cover. No user serviceable parts inside. Refer servicing to
qualified service personnel.
OUTER
SLEEVE
FUSE
BROWN
(LIVE)
CORD GRIP
BLUE
(NEUTRAL)
IMPORTANT
The wires in the mains plug should be connected as shown in the diagram.
The colours of the wires in the mains lead of the unit may not correspond with coloured
markings identifying the terminals in your plug. Connect them as follows :
The wire which is coloured blue must be connected to the terminal which is marked with the
letter"N" or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with
the letter "L" or coloured red.
There should be no connection to the earth terminal of your plug.
If a 13Amp(BS 1363) Plug is used, a 3 Amp Fuse must be fitted , or if any other type of Plug
is used a 3 Amp or 5 Amp Fuse must be fitted, either in the Plug or Adaptor , or on the
Distribution Board.
This product incorporates copyright protection technology
that is protected by method claims of certain U.S.
patents and other intellectual property rights owned by
Macrovision Corporation and other rights owners.
Use of this copyright protection technology must be authorized
by Macrovision Corporation, and is intended for
home and other limited viewing uses only unless otherwise
authorized by Macrovision Corporation.
Reverse engineering or disassembly is prohibited.
Manufactured under license from Dolby Laboratories.
“Dolby” and the double-D symbol are trademarks of Dolby
Laboratories.Confidential Unpublished Works.
© 1992-1997 Dolby Laboratories, Inc.All rights reserved.
