Handling precautions
If the surface is soiled
If the disc is brought from a cold to a warm environment moisture may form on the disc
Improper disc storage
Maintenance
Hold the disc by the edges so the surface will not be soiled with fingerprints.
Fingerprints, dirt and scratches can cause skipping and distortion.
Do not write on the label side with a ball-point pen or other writing utensils.
Do not use record cleaning sprays, benzine, thinner, static electricity prevention liquids .
Be careful not to drop or bend the disc.
Do not install more than 1 disc on the disc tray.
Do not try to close the disc tray when the disc is not installed properly.
Be sure to store the disc in its exclusive case when not in use.
Wipe gently with a soft, damp (water only) cloth.
When wiping discs, always move the cloth from the centre hole toward the occur, which will not cause noise.)
(If you wipe the discs using a circular motion, circular scratches are likely to occur, which will cause noise.)
Wipe this moisture off with a soft, dry, lint-free cloth before using the disc.
You can damage discs if you store them in the following places:
Areas exposed to direct sunlight
Humid or dusty areas
Areas directly exposed to a heat outlet or heating appliance
Be sure to press POWER to set the player to the standby mode and disconnect the AC power cord before maintaining the player.
Wipe this player with a dry, soft cloth.
If the surfaces are extremely dirty ,wipe clean with a cloth which has been dipped in a weak soap-and-water solution and wrung
out thoroughly, and then wipe again with a dry cloth.
Never use alcohol, benzine, thinner, cleaning fluid or other chemicals. And do not use compressed air to remove dust.
Disc handling and maintenance
Goodmans Product Information HELPLINE 0870 873 0080
30
