“NEO” TV SATELLITE ANTENNAS
112
www.glomex.it
ENGLISH
3. The antenna does not oper-
ate (the led on the control
unit flashes alternately red
and green)
- the coaxial cable has loos-
ened or has disconnected
from the antenna
- check the connection of the
coaxial cables
- inner failure
- contact the Service Centre
4. No status message on the
decoder
- the satellite receiver is not
installed correctly
- check the receiver connec-
tion
- alternating current fluctua-
tions
- refer to the user manual of the
receiver for support
5. Antenna pointed to the sat-
ellite (green LED) but no sig-
nal received on the TV
- if a non-Glomex splitter is
used
- The decoders are not config-
ured correctly.
- Make sure that a splitter is fit-
ted the DC Pass in all the out-
puts
- Make sure that all the decod-
ers are the dCSS type, that the
dCSS mode is selected in the
decoder configuration and
that a frequency other than the
one used by default by the
antenna board (985 MHz UB5)
is present on each decoder
connected to the control unit.
6. No image on the TV (the led
on the control unit is green)
- the receiver is off
- turn off the control unit, turn
on the receiver and then turn
on the control unit again
- the TV set is off or has not
been tuned to AV
- turn on the TV set and tune to
AV channel
- wrong cable connection on
the receiver
- check that the SCART socket
between the TV set and the
receiver is installed correctly
- the channel list is not up-to-
date
- carry out the automatic chan-
nel search in the receiver menu
- check the selected satellite
7. Intermittent images for short
periods
- the satellite signals are
obstructed by masts of other
boats, bridges, on-board
equipment, etc.
- move the boat to allow an
unobstructed view for the
antenna
- the boat is at the boundary of
the coverage area
- bad weather conditions
- go back within the coverage
area; refer to the footprints of
the coverage areas on page
108
in this manual
- wrong SKEW adjustment
- adjust the SKEW by following
the instructions on page
87
