“NEO” TV SATELLITE ANTENNAS
81
www.glomex.it
ENGLISH
2. Determine the correct position for the power
supply:
- it must be close to the control unit;
- it must be reached by the (red - black) cable
coming from the batteries or from the on-
board panel;
- it must be positioned in a dry and ventilated
area (maximum operating temperature
45° C).
3. Connect the coaxial cable of the antenna
(previously installed) to the ANTENNA IN
input on the control unit and a coaxial cable
between the RECEIVER OUT output on the
control unit and the decoder.
Make sure that the cable cores are correctly
inserted in the central holes of the relevant
female connectors on the control unit.
Manually screw in the ring nuts of connectors
F.
Once the ring nuts have been manually
screwed in, tighten by ¼ turn by means of a 11
mm wrench.
S
WARNING
The inversion of the two cables jeopardizes the
operation of the equipment. Make sure you have
correctly installed the coaxial cables. In case of
damage, GLOMEX will not be directly liable for
the damage suffered by the receiver.
4. Connect the power supply cable (24Vdc) to a
free switch for the on-board electronic
devices (min. 5A): connect the positive termi-
nal to the red cable and the negative terminal
to the black cable. The power supply line
must have cables with a minimum cross sec-
tion of 2.5 mm
2
with a length up to 4 m, of 4
mm
2
for longer cables.
S
WARNING
Do not use power supply from secondary cir-
cuits. This could jeopardize the operation of the
equipment.
S
WARNING
In order to prevent that current leakage or
charge build-up may damage the electronic
components of the antenna, make sure there is
an efficient grounding system.
S
WARNING
Pay attention not to bend the coaxial cables at a
right angle; the bending angle must always be
higher than 120°.
NOTA:
Do not cut the connectors of the coaxial
cables (the operation would not be guaranteed
any more) and always use the original GLOMEX
cables supplied, even with inappropriate dimen-
sions (too long).
Do not use different cables, as
it would jeopardize the operation of the equip-
ment.
GL00283
From the
antenna
To the multi-
switch (see
Fig. 29
)
Fig. 27
Red
Black
24Vdc power supply
cable
Fig. 28
