Glomex DANUBE NEO R500N, User And Installation Manual

Page: 80 / 146

78
www.glomex.it
DANUBE “NEO”
(R500N - R500N/DCSS)
ENGLISH
In case of problems during the update procedure,
an error message appears on your smartphone/
tablet and the control unit LED becomes red. In this
case, the control unit must be reset as indicated in
paragraph 8.1.
If the board antenna software cannot be updated
via App, use the SD Card, please refer to
paragraph 12.
9.4 SETTING THE PARAMETERS OF A
SATELLITE MANUALLY
The parameters set for each satellite can be
viewed in the advanced mode:
Orbital position
Frequency
Polarization
Symbol rate
FEC
NID
Mesh mode
To manually change every single parameter you
must click on the button “Change Sat. Setting” (
Fig.
39 ). Then a warning disclaimer is shown (Fig. 40),
press OK to proceed.
Now the parameters can be changed ( Fig. 41 ) and
tested/saved in the three SAT positions of the
control unit.
If the “Test” option is selected, the modified
parameters are cancelled when the control unit is
turned off.
If the “Save” option is selected, the modified
parameters are saved in one of the three SAT
positions as you wish.
Fig. 38A
Fig. 39