Glomex DANUBE NEO R500N, User And Installation Manual

Page: 79 / 146

77
www.glomex.it
DANUBE “NEO”
(R500N - R500N/DCSS)
ENGLISH
NOTA: The smartphone/tablet must be as close as
possible to the control unit for the entire updating
procedure.
Once updated successfully, the control unit LED
becomes green, then turn the control unit off and
back on to finish updating (
Fig. 38A ).
In case of problems during the update procedure,
an error message appears on your smartphone/
tablet and the control unit LED becomes red. In this
case, the control unit must be reset as indicated in
paragraph 8.1.
If the control unit software cannot be updated via
App, use the SD Card, please refer to paragraph
11.
9.3 UPDATING THE BOARD ANTENNA
SOFTWARE
When Glomex releases the update of the control
unit software a push notification is sent.
When the App is launched, this update is
highlighted by an icon on the upper bar on the top
right (
Fig. 38 ). This icon allows you to display the
contents of the update and proceed with updating if
you want.
Before updating, turn the control unit on and
connect the smartphone/tablet to the control unit as
indicated in paragraphs 8.1 and 8.2.
When updating the software, the control unit LED
blinks with an orange light.
NOTA: The smartphone/tablet must be as close as
possible to the control unit for the entire updating
procedure.
Once updated successfully, the control unit LED
becomes green, then turn the control unit off and
back on to finish updating (
Fig. 38A ).
Fig. 37
Fig. 38