Glomex DANUBE NEO R500N, User And Installation Manual

Page: 94 / 146

92
www.glomex.it
DANUBE “NEO”
(R500N - R500N/DCSS)
ENGLISH
3. The antenna does not operate
(the led on the control unit
flashes alternately red and
green)
- the coaxial cable has loosened
or has disconnected from the
antenna or from the control
unit
- check the connection of the
coaxial cables
- inner failure - contact the Service Centre
4. No status message on the
decoder
- the satellite receiver is not
installed correctly
- check the receiver connection
- alternating current fluctuations - refer to the user manual of the
receiver for support
5. Anomaly only for the dCSS
R500N/DCSS antennas
-
Antenna pointed to the
satellite (green LED) but not
signal received on the TV
- if a non-Glomex splitter is used - Make sure that a splitter is fitted
the DC Pass in all the outputs
- The decoders are not
configured correctly.
- Make sure that all the decoders
are the dCSS type, that the
dCSS mode is selected in the
decoder configuration and that a
frequency other than the one
used by default by the antenna
board (985 MHz UB5) is present
on each decoder connected to
the control unit.
6. No image on the TV (the led
on the control unit is green)
- the receiver is off - turn off the control unit, turn on
the receiver and then turn on
the control unit again
- the TV set is off or has not
been tuned to AV
- turn on the TV set and tune to
AV channel
- wrong cable connection on the
receiver
- check that the SCART socket
between the TV set and the
receiver is installed correctly
- the channel list is not up-to-
date
- carry out the automatic
channel search in the receiver
menu
- the selected satellite is not the
correct one
- check the selected satellite