Glomex DANUBE NEO R500N, User And Installation Manual

Page: 66 / 146

64
www.glomex.it
DANUBE “NEO”
(R500N - R500N/DCSS)
ENGLISH
2. Connect the coaxial cable of the antenna
(previously installed) to the ANTENNA IN input on
the control unit and the 1.5 m coaxial cable to the
RECEIVER OUT output on the control unit.
Make sure that the cable conductors are correctly
inserted in the central holes of the relevant female
connectors on the control unit (otherwise, there
would be a short circuit and the fuse installed on
the power supply line inside the control unit would
trip, see page 90 for fuse replacement).
Manually screw in the ring nuts of connectors F.
Once the ring nuts have been manually screwed
in, tighten by ¼ turn by means of a 11 mm
wrench.
S
WARNING
The inversion of the two cables jeopardizes the
operation of the equipment. Make sure you have
correctly installed the coaxial cables. In case of
inversion, GLOMEX will not be directly liable for the
damage suffered by the receiver.
S
WARNING
The R500N model is designed to operate with a
single decoder; therefore, do not install signal split-
ters upstream or downstream the control unit.
4a. Connect the power supply cable of the control
unit directly to the battery: connect the positive
terminal of the vehicle battery to the red cable
and the negative terminal to the black cable.
The power supply line coming from the battery
must have cables with a minimum cross
section of 2.5 mm
2
with a length up to 4 m, of 4
mm
2
for longer cables.
NOTA: With 5 m cable, MINIMUM power supply
11.5V; with 10 m cable, MINIMUM power supply
12.5V.
S
WARNING
Do not use power supply from secondary circuits.
This could jeopardize the operation of the equip-
ment.
NOTA: The polarity inversion on the power supply
blows the fuse to prevent any damage to the
antenna (see page 90 for fuse replacement).
GL00095
Fig. 16
GL00283
From the antenna To multi-switch
Fig. 17
24Vdc power
supply cable
Red
Black