Glomex DANUBE NEO R500N, User And Installation Manual

Page: 81 / 146

79
www.glomex.it
DANUBE “NEO”
(R500N - R500N/DCSS)
ENGLISH
9.5 LOG VIEW
The following values are specified in the Log:
- Log release
- Frequency being used
- Polarization being used
- FEC being used
- SymbolRate being used
- NID being used
- Modulation
- AZ turn offset
- EL turn offset
- AZ turn value
- EL turn value
- GNSS status
- Board AB temperature
- Dip switch configuration
- Antenna status
- Serial number
- Power supply voltage
- Timestamp (Date, time, minutes and seconds of
data detection)
- Latitude
- Longitude
NOTA: For privacy reasons Latitude and Longitude
can be monitored only if the user has explicitly
authorized to manage these data.
Also, some Log parameters can be registered for a
few seconds and then sent to Glomex technical
assistance by clicking on the “Technical
Assistance” button for trouble shooting if necessary
(
Fig. 42 ).
Fig. 40
Fig. 41