PART TWO - INSTALLATION
SECTION 2 - MECHANICAL REQUIREMENTS
PRO-series Model E3 Electrodeless Conductivity Transmitter
20
2.4 Integral Sensor
Mounting
☞
Figure 2-3 illustrates how to integrally mount the transmitter
onto a sensor using the supplied GLI mounting hardware kit.
1.
Using a blunt tool, open knockout hole in bottom of
swivel ball for routing the sensor cable.
2.
Attach swivel-mount assembly onto back end of sensor
using coupling provided with GLI sensor (only sensors
with “PRO1” suffix in their part number) or an appropri-
ately-sized coupling that you provide.
3.
Insert-and-twist the back cover onto the installed
swivel-mount assembly. Tighten its two screws to lock
the back cover onto the swivel-mount assembly.
NOTE:
To change mounting angle, loosen swivel-mount
assembly by lifting tab on bottom of swivel nut. Posi-
tion to desired angle and re-tighten swivel nut.
4.
Attach transmitter to back cover using its four captive screws.
GLI SENSOR
(COUPLING AND SENSOR
APPEAR DIFFERENTLY FOR
EACH MEASUREMENT TYPE)
COUPLING (SUPPLIED
WITH GLI SENSOR THAT
HAS "PRO1" SUFFIX IN
SENSOR PART NUMBER)
BOTTOM OF SWIVEL NUT
SWIVEL-MOUNT ASSEMBLY (TO
LOOSEN ASSEMBLY TO CHANGE
MOUNTING ANGLE, LIFT TAB
SLIGHTLY ON BOTTOM OF SWIVEL
NUT)
TWO SCREWS LOCK BACK COVER
TO SWIVEL-MOUNT ASSEMBLY
AFTER COVER IS TWISTED ONTO
ADAPTER.
PRO-SERIES TRANSMITTER
PRO-SERIES BACK COVER
TAB
SENSOR
CABLE
FIGURE 2-3 Integral Sensor Mounting Details
