Giga-tronics Series 12000A, Operation Manual

Page: 163 / 238

Remote Operation
Publication 31231, Rev. J, October 2003 3-47
LGL
Syntax: LGL d DM
Example: LGL -3 DM ! Set list range power to -3 dBm
Description:
The power output for each point of the list range is set with this command.
LL
Syntax: LL n1 n2 d DM
Example: LL 2 6 -3.5 DM ! Set point 6 in List 2 to -3.5 dBm
Description:
Sets the power level for point n2 of list n1 to d DM, where d is the power level (a decimal
number with possible decimal point and/or exponent) in dBm.
LR
Syntax: LR n
Example: LR 2 ! Start List number 2 running
Description:
Starts List Mode running list n . The type of list (e.g. Continuous, Single Sweep, or Single
Step) is determined by what L( ) command has been sent. ( NOTE: The status of the TR( )
command will determine if the List starts immediately or is triggered. To stop List Mode,
send the CW command) .
LS?
Syntax:
LS? n
Example:
LS? 2 ! Set up List number 2
Description:
Does the calculations for list n , and stores the calculated values in RAM. Returns 0 when
done. When the pre-calculated list is subsequently run, the first trace will run at full speed,
since the instrument will not need to do the calculations as part of executing the first trace.
Allow about 25 mS per point for this command.
LT
Syntax: LT n1 n2 d [S | MS | US]
Example: LT 2 6 20 MS ! Set the dwell for List 2, point 6 to 20 ms
Description:
Sets the dwell time for point n2 of list n1 to d [S | MS | US], where d is the dwell time (a
decimal number with possible decimal point and/or exponent) and [S | MS | US] are the
units for the dwell time. S is seconds, MS is milliseconds, and US is microseconds. No
terminator implies seconds.