56
14. Reset
You can reset the software of the bed to its initial state; e.g. for the complete
reprogramming of treatment positions etc.
PLEASE PROCEED AS FOLLOWS
:
1.
Press buttons
T 11 and T 12
of the hand control
simultaneously
and keep
them pressed
for approx. 3 seconds
until a successful reset process is
indicated by the LED in the upper area of the hand control flashing three times
(=
reset
/ s. fig. 16).
2.
The software is reset to its initial state.
The LED (diode) in the upper area of the hand control
flashes three times
to
visually
confirm
a successful reset process.
OR
1.
Press and
hold
the buttons
T 8
and
T 9
of the foot control
(see below, fig. 17)
simultaneously for approx. 3 seconds
until a successful reset process is
indicated by the LED in the upper area of the foot control flashing three times.
2.
The software is reset to its initial state.
The LED (diode) in the upper area of the hand control
flashes three times
to visually
confirm
a successful reset process.
Stored memory positions are deleted.
NOTICE!
Always wait until the hand control signals a successful reset
process by flashing the LED three times. Otherwise the reset process is
not completed!
NOTICE!
If your treatment table is equipped with the optionally available
heating system and with the optionally available foot control,
a successful reset process is signaled by all three rows of the LED
module flashing three times.
Summary of Contents for 601
Page 33: ...32 ...
Page 58: ...57 ODER FIG 16 FIG 17 ...
