Gewiss JOINON I-CON PREMIUM GWJ3201A, User And Installation Manual

Page: 78 / 324

JOINON WALLBOX I-CON PREMIUM electric vehicle recharging unit
78
The CLOUD OCPP version charging stations can be updated remotely using the methods offered by the OCPP protocol.
The other versions can be updated using the "I-CON MANAGER" APP, following the instructions in the APP.
If this is not possible, the stations can be updated using the microSD inserted into the slot of the electronic board. To
determine the firmware versions present in the product, select INFO in the menu (it can always be accessed in any
product operating mode). All the firmware versions present are shown in the relative submenu.
UPDATING THE FIRMWARE
16.
SD card slot
To update the firmware, proceed as follows:
# Action to be carried out
1 Disconnect the power supply to the product by turning off the main switch
2 Open the charging station to access the electronic board
3 Remove the microSD card from its slot on the electronic board
4 Insert the microSD card in the specific slot on your PC, to open the folder
5
Paste the update file in the main folder of the microSD card
NB: contact GEWISS SAT customer service for the most recent file <(which will also be available on the
GEWISS website, using a code search)
6 Insert the microSD card in the slot on the electronic board
7 Close the charging station and reconnect the power supply to launch the updating procedure
8 At the end of the updating procedure, the station will confirm the positive outcome via the front LED,
which will flash green 3 times.