Gestetner P7245, Hardware Manual

Page: 369 / 553

Monitoring and Configuring the Printer
200
5
msh> set parallel
msh> set usb
msh> set lpr
msh> set lpr6
msh> set ftp
msh> set ftp6
msh> set rsh
msh> set rsh6
msh> set diprint
msh> set diprint6
msh> set web
msh> set snmp
msh> set ssl
msh> set ssl6
msh> set nrs
msh> set rfu
msh> set rfu6
msh> set ipp
msh> set ipp6
msh> set http
msh> set http6
msh> set bonjour
msh> set nbt
msh> set ssdp
msh> set ssh
msh> set sftp
msh> set sftp6
❖
Configuration
• Enter “up”to enable protocol, and enter “down” to disable protocol.
You can set the protocol to “active” or “inactive”.
msh> set ipv4 {up | down}
• If you disable IPv4, you cannot use remote access after logging off. If you
did this by mistake, you can use the control panel to enable remote access
via IPv4.
• Disabling IPv4 also disables lpr, ftp, rsh, diprint, web, snmp, ssl, ipp, http,
bonjour, and sftp
msh> set ipv6 {up | down}
• If you disable IPv6, you cannot use remote access after logging off. If you
did this by mistake, you can use the control panel to enable remote access
via IPv6.