Gestetner P7245, Hardware Manual

Page: 80 / 553

Paper Recommendations
69
5
Label Paper
OHP transparencies
Paper not supported by this printer
Avoid using the following paper as they are not supported by this printer.
• Paper meant for an ink-jet printer
• Bent, folded, or creased paper
• Curled or twisted paper
• Torn paper
• Wrinkled paper
• Damp paper
• Paper that is dry enough to emit static electricity
Printer setup Make the following settings using the control panel:
• Press the
{
Menu
}
key, select
[ Paper Input ]
, and then select
[ La-
bels ] for the bypass tray's paper type.
Printer driver setup Click [ Labels ] in the [ Paper type: ] list.
Enabled paper feeding tray This paper type can be printed only from the bypass tray.
Make sure paper is not stacked higher than the paper guides in-
side the bypass tray.
Duplex printing Not possible
Additional cautions Print speed is slightly slower compared to plain paper.
Printer setup Make the following settings using the control panel:
• Press the
{
Menu
}
key, select [ Paper Input ] , and then select [ Trans-
parency ] for the bypass tray's paper type.
Printer driver setup Click [ OHP Transparency ] in the [ Paper type: ] list.
Enabled paper feeding tray This paper type can be printed only from the bypass tray.
Number of sheets that can
be set • Bypass Tray: 20
Make sure paper is not stacked higher than the paper guides in-
side the bypass tray.
Duplex printing Not possible
Additional cautions • Print speed for OHP transparencies is slower than for plain pa-
per.
• Due to switching modes, the printer will be on standby for
thirty or forty seconds after the job was received.
• We recommend that you use a 4000 ANSI lumen or brighter
overhead projector to project OHP transparencies.