gefran 2850T, Use And Installation Manual

Page: 75 / 166

73
4. CONFIGURATION
80703B_MHW_2850T/3850T_02-2019_ENG
the screen on.
To turn the screen back on once a screen saver timer has
been set, just touch the screen.
Reduce the brightness and do not always leave the screen
on to lengthen its life.
The Save and Cancel buttons appear when changes have
been made and allow them to be saved or cancelled, re-
spectively, leaving the previous configuration.
The HOME button returns to the SETUP sub-menu and
BACK to the previous page.
4.14.2.5. Information Section
The page shows the versions of the system software in-
stalled in the controller.
The buttons allow you to:
• Fieldbus : open the bus page.
• Temperature : access the internal temperature page
detected by the controller.
• System Message : access the system message page.
The HOME button returns to the SETUP sub-menu.
4.14.2.6. Fieldbus Information
The CANopen button opens the page for the CANopen
bus.
The
Modbus TCP button opens the Modbus/TCP bus
page.
The HOME button returns to the Information sub-menu and
BACK
to the previous page.
4.14.2.7. CANopen Information
The page shows information about the CANopen bus.
Node shows the controller CANopen node address and
allows you to modify it. Leave the value at 1, which must
also be set on the F-GCANs communication module. For
communication module address settings, see paragraph
“2.6. F-GCANs communication module connection dia-
gram” on page 25.
Status
displays CAN bus status:
• Configured indicates whether or not the node was
correct set.
• Present (operational) indicates whether the node is
present or not.
• Net Status
displays network status. If other than 5, it
signals an error.
• Miss counter shows the errors counted since the last
boot.
The values are read-only.
Emergency internal reserved code.
The HOME button returns to the Information sub-menu and
BACK to the previous page.
4.14.2.8. Modbus TCP Information
The page shows information about the Modbus/TCP bus.
Node shows the controller Modbus/TCP node address and
allows you to modify it. The hub can assume a value from 1
to 127 and updates the other related fields.
Status displays Modbus/TCP bus status:
• Active indicates whether or not Modbus/TCP is run-
ning.
• Configured indicates whether or not the node was