GE MobileView 4, Installation Manual

Page: 46 / 106

MobileView 4
Installation Manual
36
The following features allow you to configure all remote settings:
• Vehicle setup
• Camera setup on page 38
• Audio setup on page 46
• Alarm events on page 47
• I/O devices on page 50
• System on page 51
Note: This system configuration section provides limited detail required to accommodate initial DVR setup.
For greater detail, refer to the MobileView 4 Video Manager User Manual .
Vehicle setup
To use Vehicle setup , do the following:
1. Press the Vehicle setup button on the left side of the configuration screen
( Figure 32 on page 37) to configure your vehicle setup.
2. Enter your Depot ID (DVR number) and its corresponding vehicle ID.
3. Designate how your vehicle is tracked or monitored. If it is a fixed location, check
the Fixed location radio button and enter the location's coordinates. If using a
mobile recorder, check the Mobile recorder radio button.
4. Note the software version information.
5. Select the
Display Disk Full as Fault
check box. The Camera status output,
J11.8, turns on when the archive partition is full. (See Status output connections on
page 22).
6. Select the
Display Future Recording Time Warning
check box. The
Camera status output, J11.8, turns on when the current time precedes recorded time
by more than 5-minutes. (See
Status output connections on page 22).
7. Click Close .