GE MobileView 4, Installation Manual

Page: 26 / 106

MobileView 4
Installation Manual
16
Mounting location adjustments
For cameras mounted on the street side of the bus or surface-mounted facing backward, you
may need to invert the camera. To adjust the camera for specific mounting locations on the
vehicle, do the following:
1. Figure 11 shows (the default) orientation of a camera mounted on the curb side of
the bus, the backside of the bus, or in a forward-facing position on the dashboard.
(Note that the lens set screw and the wiring harness are at the top of the camera.) For
cameras mounted on the street side of the bus or surface-mounted facing backward,
remove the two side set screws and lift the camera out of its bracket.
Figure 11. Loosening the camera from the mounting bracket and inverting the camera
2. Rotate the entire camera assembly 180º.
3. Insert the camera into the bracket, and replace the set screws. The lens set screw and
the wiring harness should be positioned at the bottom of the camera ( Figure 12 ).
Figure 12. Reattaching the camera in the mounting bracket
Wiring harness Lens set screw
Lens set screw
Wiring harness