GE MDS entraNET 2400, Technical Manual

Page: 80 / 220

70 MDS entraNET Technical Manual 05-4055A01, Rev. E
•
EndPoint Logging
—This selection is used to specify whether
endpoint logging is enabled or disabled. [
Enabled, Disabled;
Enabled
]
3.8.1 Remote Management Menu
The Remote Management Menu ( Figure 3-33 ) allows selection of a
particular Remote to manage, based on the radio Unit ID number
(generally the last four digits of its serial number).
Figure 3-33. Remote Management Menu
•
Remote to Manage
—Radio address of the Remote to be managed
(typically a four-digit code).
•
Manage Selected Remote
—Displays the screen shown in
Figure 3-34 on Page 71 , which contains several parameters used
to set the characteristics of Remote radios in the network.
•
Broadcast Remote Programming
—Selecting this item brings up a
submenu ( Figure 3-36 ) where you can initiate the broadcast of
new firmware images and Remote restart commands.
NOTE: Before programming a Remote radio over the air, be sure to set
ETHERNET BRIDGING
( see “Bridge Configuration Menu” on
Page 51 ) from
ALL
(default) to either
DISABLED
or
NO
BROADCAST/MULTICAST
.
Otherwise, you might experience sync errors, or programming
might not complete. Excessive broadcast/multicast traffic
from a connected LAN can also cause problems.