GE MDS entraNET 2400, Technical Manual

Page: 69 / 220

05-4055A01, Rev. E MDS entraNET Technical Manual 59
View Current Settings Screen—Serial-to-Serial Example
If you choose
View Current Settings
from the Serial Configuration Wizard
Menu , you see a summary screen ( Figure 3-25 ) showing the serial
configuration settings. This is the same screen that is also shown at the
end of the configuration process. Here, you can choose the letter of an
item to change, or exit the Serial Configuration Wizard completely.
NOTE:
Selecting any item other than
Commit Changes and Exit Wizard
returns you to the configuration process. After making the
necessary change(s), you can use the
Continue Wizard
selection
repeatedly to reach the end of the configuration process, and
then exit.
Invisible place holder
Figure 3-25. Serial Configuration Current Settings Screen
(Serial-to-Serial example)
The following text explains the key settings for the Serial Configuration
Menu (serial-to-serial example).
•
Port Status
—This selection is used to enable or disable the
serial data port for payload data operation. Normally,
COM1
is set to
Disabled
to permit console terminal operation.
NOTE:
When
COM1
is enabled for data, management of the radio
through
COM1
is disabled. This problem can be remedied by
typing the escape sequence + + + followed by .
This restores
COM1
to console terminal mode. You must log in
again.
SHIFT ENTER