GE MDS entraNET 2400, Technical Manual

Page: 118 / 220

108 MDS entraNET Technical Manual 05-4055A01, Rev. E
MODE=<mode>
—Sets the console port interface mode.
MODE
cannot be
set to
DATA
unless the device has been authorized for serial payload. To
escape from data mode, enter three conse characters to
COM2
with at least 100 ms between entries.
CONSOLE
—Places
COM2
in command-line mode.
DATA
—Places
COM2
in transparent data mode.
BSP
—Places
COM2
in Basic Serial Protocol mode.
INT_LOOP
—Places
COM2
in internal loopback mode.
EXT_LOOP
—Places
COM2
in external loopback mode.
RXDELAYCHARS=
—Sets the inter-packet receive gap size in character
times (1-65535).
TXDELAY=
—Sets the inter-packet delay in milliseconds (1-65535). The
minimum
TXDELAY
setting should be set to two times the
Dwelltime
setting. When
TXDELAY
is set to less than twice the
Dwelltime
setting, the
measured inter-packet delay can increase up to one dwelltime period
(7, 14, or 28 ms).
CONFIG Saves or displays the current configuration. The output is in a format
that can be copied back into the command line in order to set the
configuration.
Optional arguments:
SHOW
—Displays the current configuration. This is a read-only response.
SAVE=FACT
—Programs the current configuration into the Factory
Default configuration table. The factory default is used to restore the
configuration when the system detects a data corruption.
DEVICE Displays the device configuration, and allows setting of the
OWNER
,
NAME
, and
LOCATION
.
Optional arguments:
CMD
—Displays all settable optional arguments and their current values.
You can copy this list to a text file as a record of your configuration.
COMPANY
—( read only ) Displays the company name.
MODEL
—( read only ) Displays the radio model number.
PRODUCT
—( read only ) Displays the product name.
REV
—( read only ) Displays the software revision ID.
OWNER
—Sets or displays the owner information (1-40 ASCII
characters).
NAME
—Sets or displays the radio name (1-40 ASCII characters).